AIS Router AI2524 Manual do Utilizador descarregar pdf (Página 303)

100

101

Chapter 12: AI2524 X.25 Configuration Steps

August 1997 Page 12-45

2524UM

This configuration specifies that traffic from any other interface on

Cisco Router C4 that is intended for any NSAP address with NSAP-

prefix 38.8261.20 will be switched through Serial 0.

interface serial 0

encapsulation x25

x25 address 00002

x25 map cmns 38.8261.20

Configuration for Router C3

This configuration specifies that any traffic from any other interface

intended for any NSAP address with NSAP 38.8261.20 will be

switched to MAC address 0800.4e02.123f through Ethernet 0.

interface ethernet 0

cmns enable

x25 map cmns 38.8261.20 0800.4e02.123f

This configuration specifies that traffic from any other interface on

Router C3 that is intended for any NSAP address with NSAP-prefix

38.8261.21 will be switched through Serial 1.

interface serial 1

encapsulation x25

x25 address 00001

x25 map cmns 38.8261.21

Create X.29

Access Lists

Protocol translation software supports access lists, which make it pos-

sible to limit access to the access server from X.25 hosts. Access lists

take advantage of the message field defined by Recommendation

X.29, which describes procedures for exchanging data between two

PADs or between a PAD and a DTE device.

To define X.29 access lists, perform these tasks:

Create an Access List

Apply an Access List to a Line

When configuring protocol translation, you can specify an access list

number with each

translate

command. When translation sessions

result from incoming PAD connections, the corresponding X.29 ac

cess list is used.

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 417 418

Comentários a estes Manuais

Sem comentários

AIS Router AI2524 Manual do Utilizador Página 303

Comentários a estes Manuais